Replaced ground cable in trunk, it was so bad I was able to remove it by hand. It just fell to pieces, replaced the terminal and the cable. First time to see a negative cable so thin, probably 6 gauge.
What did you do to your LX today
6061 - 6080 of 7831 Posts
Finally got her started and running after over 5 months of sitting.
Reworked redone heads ( new valves, seats, retainers, and springs)
![]()
Pushrods
Lifters
Cam
Oil
Coolant
Shorty wires
Longtubes
Timing set
Painted plenum, valve covers, fuse box, washer fluid lid, power steering pump, psp cap, timing cover, radiator shroud covers, strut covers, and engine cover
(Pic right after startup, not all pieces are in)
![]()
Sent from my Z981 using Tapatalk
Reworked redone heads ( new valves, seats, retainers, and springs)
Pushrods
Lifters
Cam
Oil
Coolant
Shorty wires
Longtubes
Timing set
Painted plenum, valve covers, fuse box, washer fluid lid, power steering pump, psp cap, timing cover, radiator shroud covers, strut covers, and engine cover
(Pic right after startup, not all pieces are in)
Sent from my Z981 using Tapatalk
2
just washed it
![]()
Factory reproductions?? Or another company??Finally got the new wheels on the car! I'll have to steal the wife's camera to get some better quality pictures soon.![]()
![]()
![]()
![]()
Sent from my iPhone using Scat Pack Forums
Workin on a slight front end makeover. I got rid of the LED sequential turn signals that were mounted on the edge of the bumper. The control boxes were starting to wig out on me. Sometimes the lights wouldn't work at all, sometimes the LED sequencer wouldn't work, and on one of them the white LEDs were faded in two of the segments. I plan on doing something different down the road....
I wrapped the center section of the grille in cheap eBay Carbon Fiber vinyl. Mistake. It was very hard to work with, it lifted, and the carbon fiber pattern was delaminating and it just looked like crap. So this weekend I corrected my mistakes. I went with 3M Satin Dark Gray metallic. Also corrected a loose wire and got my x-lume lighted SRT badge working again. The grilles and fog light bezels were also spruced up and repainted with Duplicolor Bumper/Trim paint.
Still a few more things I'm working on, but here is how she sits now.
![]()
![]()
Here is a before shot:
![]()
I wrapped the center section of the grille in cheap eBay Carbon Fiber vinyl. Mistake. It was very hard to work with, it lifted, and the carbon fiber pattern was delaminating and it just looked like crap. So this weekend I corrected my mistakes. I went with 3M Satin Dark Gray metallic. Also corrected a loose wire and got my x-lume lighted SRT badge working again. The grilles and fog light bezels were also spruced up and repainted with Duplicolor Bumper/Trim paint.
Still a few more things I'm working on, but here is how she sits now.
Here is a before shot:
3
6061 - 6080 of 7831 Posts
