It didn't toss a code?
Timing Help
Good evening fellow moparians…
So I’ve recently tore down my 2005 5.7 to add a cam, lifters, pushrods, springs and delete MDS. While I was in there I put in a new oil pump, water pump, timing chain and gear , front and rear seals as well as new crank and cam position sensors. Since then I haven’t been able to get the car to idle on its own. Have checked and rechecked the pushrods to make sure they’re seated correctly, and decided to pull the timing cover off to check the timing. I used a laser level to help me see the timing marks and make sure they’re lined up.. if any of you are familiar with this type of procedure can you tell by the pictures if this is correct?
So I’ve recently tore down my 2005 5.7 to add a cam, lifters, pushrods, springs and delete MDS. While I was in there I put in a new oil pump, water pump, timing chain and gear , front and rear seals as well as new crank and cam position sensors. Since then I haven’t been able to get the car to idle on its own. Have checked and rechecked the pushrods to make sure they’re seated correctly, and decided to pull the timing cover off to check the timing. I used a laser level to help me see the timing marks and make sure they’re lined up.. if any of you are familiar with this type of procedure can you tell by the pictures if this is correct?
Attachments
1 - 2 of 14 Posts
1 - 2 of 14 Posts
