LX Forums Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
I started chatting about this on another thread, but fits better on its own thread now that’ll I have dug into it:

I am putting ‘07 MSRT seats into my ‘07 MRT
Driver side went in easy, no airbag light, power controls work.
Rear went in easy, no issues.

Passenger front:
My R/T is mechanical, the SRT is power.

I don’t care if it is power or not, just want seat in and working.
Started switching frames - took bottom cushions off, removed levers on sides, unclipped the cover and am ready to pull the cover off to swap foams and covers.

1) How do these headrest mounts come out?
2) Anything else I need to be aware of to swap foams and covers?

Thanks!


Sent from my iPhone using Tapatalk
Those can suck. You need to pull the seat cover up over the frame, move the cushion out the way and pinch the tabs at the bottom, then tap them up with a small plastic mallet.
 

·
Registered
Joined
·
11 Posts
…the reason I ask is the seat has a pin for the power wire but the body side does not. I’d like to get the corresponding female receptacle to put in the body side of the plug for power so I don’t have to chop onto the seat harness.


Sent from my iPhone using Tapatalk
Mopar might make a connector repair package for the seat, get your vin and call a local dealer.If not check some salvage yards for that specific connector.
 
1 - 4 of 4 Posts
Top