LX Forums Forum banner
1 - 5 of 5 Posts

· been around more than once
Joined
·
6 Posts
Discussion Starter · #1 ·
I just about finished my amp install on my 2006 Daytona Charger. I have the JL amp, and a 10 inch type R alpine sub. I had this in my last car and loved it, so Im just transfering it over to my new car. Everything is done, but im getting basically no sound out of the sub. The amp levels are all fine, and I even turned them up to check. My concern is how im getting the speaker input for the RCAs, and im guessing this is the problem. Im using one of those Speaker wire to RCA adapters, and I hooked it up to my stock Sub in the rear deck. This unit does have a 10ohm impedence level adjustment, and I went from one side to the other, and it went from No sound, to a tiny Hair of sound. Should I have used the 6x9s instead of the sub for this part? Thanks, ill contiue to search, but thought I would ask in hope of a faster reply. Thanks.
 

· 345 Go!
Joined
·
1,164 Posts
Seems logical that if the RCA adapter you are speaking of was designed to convert amplified level signal to line level, I would think to use the 6x9 signal before the sub signal... that said, There is no reason (that I can think of) that it would not work just as well with the stock subwoofer signal as you have attempted..

But something must be wrong... I'm sure someone with more car audio experience (Robbyho... where are you?) can set ya straight ...

Might help if you give specs or even a pic of the RCA adapter you are using...
 

· been around more than once
Joined
·
6 Posts
Discussion Starter · #3 · (Edited)
Thanks, just did more testing, crappy converter. I disected an old set of RCAs, and wired that up, and it works fine. Now I just have to clean it up. Ive also decided, these cars need more than just a 10inch Type R. It sounds fine in other "small" cars, but not enough in this car.
 

· Black Charger 06
Joined
·
1,559 Posts
Kolk1 said:
Thanks, just did more testing, crappy converter. I disected an old set of RCAs, and wired that up, and it works fine. Now I just have to clean it up. Ive also decided, these cars need more than just a 10inch Type R. It sounds fine in other "small" cars, but not enough in this car.
So where are the pics of this beast? :pepper:
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top