did you install the new piller overtop of the stock one or did your remove the stock one and just put the new one in place of it? I was told to install the gauge piller over the stock one and there is a gap at the top. looks bad.
Painting Gauge Pods to Match SRT8 A-Pillars
5
I looked all over for a good matching paint, but struck out left and right. I don't know if different years and models have different A-pillars, but the '06 SRT8 is a tannish color with tiny black specks in it. This is what I wound up doing.
To prep the black gauge pod, all I did was scrub it thoroughly with a green scotch pad and hot, soapy water to get it super clean and dull the finish.
Started with this:
![]()
This is the paint and clear coat that worked pretty well. I kept spraying light coats of color and compared it with the stock pillar I was going to cover with the gauge pod. It didn't look close until I sprayed a few light coats of the clear.
![]()
Still didn't match the right side as well as I wanted, so I painted that one too.
![]()
This is the end result. It's not a perfect match to the headliner, but all in all it's not too bad.
![]()
![]()
To prep the black gauge pod, all I did was scrub it thoroughly with a green scotch pad and hot, soapy water to get it super clean and dull the finish.
Started with this:
This is the paint and clear coat that worked pretty well. I kept spraying light coats of color and compared it with the stock pillar I was going to cover with the gauge pod. It didn't look close until I sprayed a few light coats of the clear.
Still didn't match the right side as well as I wanted, so I painted that one too.
This is the end result. It's not a perfect match to the headliner, but all in all it's not too bad.
