[rob_in_korea]

Hello everyone. I have been a member over at chargerforums for a little while now and I decided to come over here and post.

I am a US DOD contractor living and working in Seoul, South Korea. I was in the Army for five years (finished in 2003) and I have been a contractor for the past three years. I am 26 years old and recently married. I will post photos sometime later. Anyway.....

I am thinking of ordering headers within the next month or so. My questions are:
1. Do long tube headers have any negative effect on ground clearance?
2. With headers and hi-flow cats (I have magnaflow cat back and K&N CAI) what HP gains can I expect? (I am thinking 15hp).
3. I understand about the problem with the CEL which is ok with me as long as it doesn't have a negative impact on performance, so does it have an impact on performance?
4. Lastly, any recommendations? I was thinking of going with Kooks....

Thanks for all the help.

 

[PowerWagon896]

Hello everyone. I have been a member over at chargerforums for a little while now and I decided to come over here and post.

I am a US DOD contractor living and working in Seoul, South Korea. I was in the Army for five years (finished in 2003) and I have been a contractor for the past three years. I am 26 years old and recently married. I will post photos sometime later. Anyway.....

I am thinking of ordering headers within the next month or so. My questions are:
1. Do long tube headers have any negative effect on ground clearance?
2. With headers and hi-flow cats (I have magnaflow cat back and K&N CAI) what HP gains can I expect? (I am thinking 15hp).
3. I understand about the problem with the CEL which is ok with me as long as it doesn't have a negative impact on performance, so does it have an impact on performance?
4. Lastly, any recommendations? I was thinking of going with Kooks....

Thanks for all the help.

The Mopar LT headers/hi-flow cats fit, there are NO CELS and I picked up .2 - 2MPH improvement in the 1/4 mile according to Superchips data log readouts.

They are available through a group by from MPSC (a site supporter) for $1015 shipped.

Hears a video clip. Click here to watch Mopar-LT-Headers

 

[Hemi31]

There are no Mopar headers available for an SRT

 

[rob_in_korea]

Thanks for the responses. Your car sounds great PowerWagon. As Hemi31 stated, unfortunately Mopar does not make headers for the SRT. If the longtubes hang lower than stock I am not sure I can buy them. There are a ton of potholes and speedbumps over here. The speedbumps are all different sizes and I have scraped the front of the car numerous times (many of the bumps you can't go over at an angle). Maybe I will just by the hi-flow cats....

 

[tbyrne]

Dynatech's SuperMaxx headers are available for the SRT-8 -

They are 1 7/8" and come with highflow cats/connection pipes. Fitment is pretty good. They tuck up nice under the car.