Search Results for ‘ring’

New 426 based 6.4 install please read article and your thoughts ???? Full article here Break In Secrets--How To Break In New Motorcycle and Car Engines For More Power (mototuneusa.com)What's The Best Way To Break-In A New Engine ?? The Short Answer: Run it Hard ! Why ?? Nowadays, the piston...

New 426 based 6.4 install please read article and your thoughts ???? Full article here Break In Secrets--How To Break In New Motorcycle and Car Engines For More Power (mototuneusa.com)What's The Best Way To Break-In A New Engine ?? The Short Answer: Run it Hard ! Why ?? Nowadays, the...

Hello I have a 2005 Magnum 5.7 with a slipping A/C clutch. The rubber isolator between the inner clutch ring (where the bolt goes through) and the outer ring (not the actual pulley) is coming apart and allows for relative motion between the two previously mentioned metal rings. When the A/C is...

dup delete

I'm cheap and lazy. all in 80.00 to make my own electric ring grinder. Couldn't see myself hand cranking. 300rpm @12 volts can speed it up with 24 volt power supply. Lone star foot peddle for on and off operation. Forward and reverse switch depending on cutting operation

I just did a 3.91 getrag swap from East Coast Moparts on my 08 300c. First test drive and the esp/bas light came on. I searched on here and changed the sensor with no luck. But I noticed that I had a yellow plastic sticking out from where the tone ring is. Got a replacement from highhorse and...

I recently bought a 2015 Charger Pursuit with the 5.7 and AWD. When I bought it it had the ABS and Trac Control lights on and the AWD was "unavailable". The codes were C0034, U0415 and U140A plus a bunch of other codes, but the battery had been run down and those cleared right up. everything...

Any ideas how to fix. i'm thinking a damaged or dirty o ring. can they be replaced?

I'm looking for a ring and pinion set for the stock h210mm carrier on the early r/ts. Specifically I'm looking for the 3.55 gearset. Richmond produced them, then moved to Motive and stopped producing them. If anyone has any laying around, along with the bearing set ideally, I will buy.

My car started having the ABS and BAS light illuminated the other day. The code is U1417 (IMPLAUSIBLE LEFT WHEEL DISTANCE SIGNAL RECEIVED) I replaced the tone ring on the left rear axle (it was in multiple pieces when I removed the hub) The ABS and BAS lights are still on though. Should they...

What is involved with replacing the tone ring on a getrag axle and are the rings available to purchase?

WTB OEM Radio and AC/Heat controls WITH CHROME TRIM ring for Magnum RT. 2 Radio/3 Heat/AC

I've got a 06 charger 5.7 that needs an engine. I've got a perfectly fine 10 ram 5.7 sitting on a stand. I've been doing alot of research and i'm seeing some foggy data bout the camshaft being the issue. Not having VVT on the 06 there's nothing to run oil to the phaser on the cam to keep it...

Tone ring, if you broke your axle i could use your tone ring. pm me ..thanks CK.

DBA 5000 SERIES FRONT ROTOR RING REPLACEMENT 2015-2018 392//6.4L/6.2L CHALLENGER/CHARGER W/ 6 PISTON BREMBO To Order: DBA 5000 Series Front Rotor Ring Replacement 2015-2018 392//6.4L/6.2L Challenger/Charger w/ 6 Piston Brembo Chris

Hello All, I searched through the Gen 1 Knowledge base, but could not find any info... How do you remove the gearshift knob and selector plate? Wife spilled coffee or coke all over it and now when you get in it and put it in gear it "sticks". :banghead: I have the chrome trim ring and the...

Getting some DTC codes for the right front abs, going to try to just replace the sensor and tone ring, but cannot for the life of me find the part number or part. 2006 300C SRT8. Thanks, J man

I am trying to upgrade my gearing from the sluggish factory gear and get some speed on that 0->60. The easy part: My car has the 2.82 gear. which is sluggish for this type car. chrysler did this to increase gas mileage. I want 3.55 gears or 3.73 gears. The harder parts: Chrysler makes 2...

What are the differences in 5.7 stock cranks over the years? I need a couple of cranks to rebuild two '04 engines. There are a lot of later model ('09-'15) cranks cheap, but will they work ok in the older ones? Tone ring differences? I'm thinking the later ones have a different front (VVT). I...

A balding white haired man walked into a jewellery store this past Friday evening with a beautiful, much younger girl at his side. He told the jeweller he was looking for a special ring for his girlfriend. The jeweller looked through his stock and brought out a $5,000, ring. The man said, "No...