Search Results for ‘hard’

I would like to improve upon the OE axles, am less than 500HP, and am going to convert a 215 Diff to WaveTrac and while I think the OE axles will be OK for me but I would like to see something else more in reach. The car has the mileage I may as well replace them while under there. The 2009...

I've been seeing on plenty of facebook groups lately that the chrysler 300 bolt pattern was 5x114.3 until approximately 2012. I was always under the impression that these cars have always been 5x115. Does anybody with hard facts have pictures or measurements to set in stone what information is...

I had a line rupture today on my way home from work, a bit of a scary moment, tried to time the traffic lights all the way home after getting off the highway. Anyways, does anyone know the diameter of the hard steel brake lines for 05 Magnum RT RWD? These factory replacement parts have been...

Over the last several months I've been chasing several demons that have been robbing my 2006 SRT8 of performance. Purge valve and filter in the fuel tank. This was confirmed at the dealer and I'm in the queue for a new fuel tank Vacuum leak from hard lines. I replaced all the vacuum hard...

I have a 2005 Magnum R/T with 300000 miles on the rack and pinion and about 100000 miles on the pump. In the last month the steering has been getting stiff- hard to move. The fluid is full, about 100000 miles on it too. Where do I start trying to figure this out?

So, after years of getting the runaround from FCC, letters in the mail but never any real help, and multiple trips to the dealership I am FINALLY almost at the end of this journey. My 06 Magnum got hit with the stalling issue after filling the tank and it's been no end of headaches and...

So I recently swapped over to my winter tires/rims from the drag setup. I live in NJ so it's just time to be ready for snow. Anyway, when on the drag radials, the car had a noticable sway when accelerating hard. I've driven cars on slicks before, and just attributed this to the bias ply wiggle...

I bought my 2016 Scat Pack Challenger used with 8k miles and the stock Goodyear Eagle RS/As still have decent meat on them, but I am not liking them at all...if the road is wet at all and you step on the gas too hard in 2nd or 3rd, the back end goes sideways. Being a big heavy chassis it...

Why??? Because there is a lot more cosmetic stuff one can do on the other trim levels....as well as SRT front ends are hard to come by. I would think a SXT or RT can just fasten on easy...am I wrong?

GM is recalling the 2019 #Chevrolet #Corvette #ZR1 over a concern that hard braking or hard acceleration will cause the airbag system to not function in the event of a crash. Reference from Torque News at 2019 Corvette ZR1 Recalled Over Airbag Failure Risks.

What is the stock size speakers in the doors and at the rear? Read there are 6x9 in the doors and 5 1/4 in the rear, but saw a video that showed the rear speakers as 6x9 also. Want to get some 3-way speakers to replace the stock ones. Also the dash speakers, what do people do with those. Would...

Anyone have the Wicker Bill on their 1st gen 300 srt that can post a picture, how do you like it, was it hard to install and is it durable? where did you purchase. thanks.

Who has partition backups of their MyGig hard drive that can be shared to do repairs of bad data? I can mount my hard drive to my computer and read most of the data OK, but some files are damaged. If someone has backups of their partitions, I might be able to repair with them.

I have an 08 RT 155k miles, and i am running the perf 93 CAi tune through the diablo trinity. I am noticing that during heavy pulls with the engine (usually in a higher gear) and not shifting (with or without autostick), my long term knock sensor will retard timing by up to 8.50°. My short term...

Hey everyone I'm new to this forum and I live in Indiana. I'm on the market for a Magnum R/T. I know they're hard to find but anyone selling one message me! Thanks! I'm willing to travel some also

Would anyone if there is any truth to what a dodge salesman told about my Alpine radio in my 2018 Charger RT...that there is a 40 GIG hard drive in the radio...and if so how is it accesable :roll:

Hi everyone, I am pretty sure my hard drive in my RER Head unit is failed, I have looked online and found that people are selling the replacement hard drives at really high prices. over 100 USD plus shipping. I did manage to find one on EBAY for 40 and though I won the auction but someone...

Brand new black hood pin kit for really any car. Was meant for a TA Challenger. Original Mopar parts. All hardware included.. These are hard to find and pricy from the dealer. Asking $250 shipped or trade for a intune, or a transformer and some cash.

Any one install one of the vip duraflex 3 piece wing on their Charger? If so how hard was it to install?

My 2006 Charger Daytona has relatively fresh R1 rotors and premium ceramic brakes from Advance Auto that I installed about a year ago. Lately, there is a noise coming from the front left brake during a hard stop. It's a deep rubbing sound that last for a split second, stops and then repeats...