LX Forums Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 95 Results
  1. General LX Discussion (1st Gen - 2005 to 2010)
    I can't access my original thread so making a new one. I need to know how much voltage the pasenger door module is supposed to see? My door locks don't work, only thing that works is unlocking drivers door. Other doors do not respond. I used AlfaODB to send voltage to door module and it...
  2. Automotive Electronics (Audio & Video)
    I would like to install LED map pocket lights in my door panels. (the 08-10 Chrysler 300's had this option) I have the door panels but my 06 wouldn't have the +/- wiring in the door harness to illuminate them. I would like to have them illuminate with the interior lights when they are...
  3. General LX Discussion (1st Gen - 2005 to 2010)
    I have 2 Magnums 2005 and a 2008 both with manual temp controls. When I attempt the recalibration procedure (hold down defrost with blower off and release after 5 sec), I can hear the two blend door motors cycle , but the recirculate door does not move / calibrate. I even tried to recalibrate...
  4. Charger Discussion (3rd Gen - 2015 +)
    Wondering what the process in painting PHG.. Plum Crazy Purple Pearlcoat. How is it applied? Base purple? Pearlcoat and sealer? Clear coat? How many coats??? How bad are our armrests??? Can a deer that impacts drivers side tire/wheel , fender and door Cause damage to the drivers side armrest...
  5. Magnum General Discussion (2005 - 2008)
    Hello. I just bought an 05 R/T and the previous owner changed out the factory radio and speakers- didn't do a very good job. In doing so he lost the screw cap for the drivers side door (behind the interior door handle). Anyone know where I could get one? I think I may have to go to a junk yard...
  6. General LX Discussion (1st Gen - 2005 to 2010)
    2010 300, I am going to be replacing the lower hinge. Just wondering if anyone has done this WITHOUT removing the door or the front fender? It looks like it can be done, but I am worried about the alignment afterwards. It's a tight fit and trying to make adjustments after wards would be a pain...
  7. Charger Discussion (3rd Gen - 2015 +)
    To locate my ideal parking position at home, I like to open the door to see a marked spot on the ground. My 2020 Charger and my wife's 2019 Charger doesn't like to move when the door opens. Is there an over-ride programming for this?
  8. Magnum General Discussion (2005 - 2008)
    I found a crack in the faux carbon fiber on the driver's door panel. It's the piece that sits just below the window, and runs from the back of the panel to near the inside door release. Is that trim piece available separately, or does the whole door panel need to be changed? Thanks for any...
  9. General LX Discussion (3rd Gen - 2015+)
    Class action lawsuit regarding the door panels coming apart (that I have read several posts about here): Class Action Lawsuit Alleges Dodge Charger Door Panels Defect | Top Class Actions
  10. General LX Discussion (1st Gen - 2005 to 2010)
    Both of my key fobs poo'd the bed, corroded, rusty, soldered on 10 times, etc.... Best source for new? They are larger 3 button (FCC KOBDT04A) like this: 2006-2009 Mitsubishi Raider OEM Key Fob KOBDT04A Other question is... I have a few transponders keys I was able to program and they start the...
  11. Magnum General Discussion (2005 - 2008)
    I have been wanting to update the two-tone factory interior of my Magnum SRT8 to the full Dark Slate gray interior from a later 08-10 Chrysler 300C. I've been monitoring the LKQ Pick A Part junkyards since the beginning of the year for the right interior to come along, and it finally happened a...
  12. Magnum General Discussion (2005 - 2008)
    Not the piece on the side, the stuff around the window. The parts on the door I removed are better than the replacement. Any suggestions?
  13. General LX Discussion (1st Gen - 2005 to 2010)
    I picked up a door from a junkyard (right front). Anything I should look out for when I swap them?
  14. Magnum General Discussion (2005 - 2008)
    Today I noticed the window and door lock switch panel on my driver's door was popped down out of position. No ides how it happened. What's the easiest way to get it back in place?
  15. General LX Discussion (1st Gen - 2005 to 2010)
    Hey guys so I’m having a little issue on my 2008 charger. So about a year or so back, I got my ignition replaced by dodge due to a recall. With that I received 2 brand new key fobs. Everything worked fine up until now. Both key fobs do not lock or unlock the car. When I press the unlock button...
  16. Charger Discussion (3rd Gen - 2015 +)
    I'll post some pictures later. Basically it's a PIA. Did the drivers door yesterday and the passenger door today. I had about 5 screw ups that I'll share. 1. Don't push the center pin in too far on the fastener on the panel. It falls into the door never to be seen again. I removed the...
  17. Newbie Check-In
    Hello All, Recently purchased a '20 Charger 392 Widebody in late February. Absolutely love this vehicle. What I have done so far: Got her tinted Added Door visors Added the Sto N Go Front license plate
  18. General LX Discussion (1st Gen - 2005 to 2010)
    Has anyone grafted two different LX door panels together? I have a complete set of double black panels from a Charger which I want to install in my Magnum with the two tone black and light gray panels, however, it appears that the top half of the panels differ slightly between LX models. Looking...
  19. General LX Discussion (1st Gen - 2005 to 2010)
    Haven't driven Maggie for like 2 years, since I failed tech inspection and never bothered to fix it. Well, I am trying to fix things before I put up the car for sale. #1 problem: I need to roll down driver side window to open the door from outside. Inside door handle does nothing. Before I take...
  20. Challenger Discussion (2008 to 2014)
    My 2010 SE Challengers heater just blows out cold air.Here’s what I checked so far. Checked all 3 door actuators and they all 3 are working Checked both the in and out heater core hoses and they both were warm or hot after the car came up to normal running temp Car comes up to normal temp like...
1-20 of 95 Results
Top