LX Forums Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 20 Results
  1. Magnum General Discussion (2005 - 2008)
    I've got a 2005 Magnum RT. A few years ago I begin to get an intermittent airbag light on my dash that would go out with movement of the steering wheel and tilt/telescope. It's now permanent, has been for more than a year. Everything I've read says this is more than likely caused by the...
  2. Transmissions Gears & Diffs
    Hi all, I just noticed that both side cv axles boots are torn on my car… 06 Chrysler 300c srt8. Stock rear. When trying to look up replacement parts it’s very difficult to narrow down which are the correct axles I need to order. From my research on the forum, my understanding is I need 28...
  3. Magnum General Discussion (2005 - 2008)
    Any concerns or issues before I start maxing out my credit cards? I believe the weakest part is the transfer case, am I correct?
  4. Misc LX Mods
    Got one of these for Christmas. Installation should have been simple but Petty's didn't include new hardware like they were supposed to. I tried to reuse the factory nuts but they failed when torqued to the required 35 foot pounds. Finding the correct replacements was a challenge but finally...
  5. The SRT-8 (6.1L and 6.4L V8)
    Everywhere i've looked says it's an M8 bolt, but it's an M10 bolt. Anyone happen to know where to get the right one, or the correct part number? 2006 Charger SRT8 6.1 engine. Parts that i'm running Water pump part number - 04792838AB Idler pulley - 04891720 AA Dealership sold me the...
  6. Automotive Electronics (Audio & Video)
    Hey guys and gals, I’m going to be installing my JBL interiors this week and couldn’t find speaker wiring diagrams anywhere. Anyone know where I can find it so I’m sure my polarities are correct?
  7. General LX Discussion (1st Gen - 2005 to 2010)
    Hi All, I'm getting my 07 Magnum SRT8 ready to sell. Can anyone tell me what is the correct part number for the front belly pan? I can find a number for a non SRT8, but they all say does not fit SRT8. Some of those come with the hardware also, which would be helpful. I need the correct front...
  8. Charger Discussion (3rd Gen - 2015 +)
    Okay, try not to laugh. Trying to order spare fuses both bladed & cartridge. I believe the fuses are Mini-Bladed, ATM style correct? Are the Cartridge style's: Mini - Low - Tall/Standard? Thanks in advance.
  9. Engine / Intake / Exhaust / Performance
    Best place to purchase for 07 300. o2 sensors will plug right into these correct? TIA
  10. General LX Discussion (1st Gen - 2005 to 2010)
    Monday afternoon, just before I got off the freeway coming home from work, one of the tranny cooling lines burst, right along the drivers side of the radiator where there is a rubber section. Man it made a big time mess spraying tranny fluid all over the serpentine belt and pulleys. I've never...
  11. Charger Discussion (1st Gen - 2006 to 2010)
    So I’m doing the cam on my 2010 charger 5.7 and I got the pushrods mixed up do someone has the Correct order they go in for the driver side standing outside the car
  12. Magnum General Discussion (2005 - 2008)
    Guys I’m looking to replace those metal covers that wraps around the sway bar bushings. Is there a correct name for these? Aswell as a part number and or place to start looking for new replacements???
  13. Challenger Discussion (2015 + )
    Gents, hers my thought behind the madness. Please correct me if Im wrong or headed in the correct direction. Im considering using E85 for several reasons. 1) $1 cheaper than premium, 2) increased HP. If my math is correct i would get a much higher octane for 70% less in price, and a cleaner...
  14. Factory Reproductions
    I ordered a set of 9.5x20's for my 300c Friday. Just wanna calm my worries that my assumptions are correct. I was gonna put 245/45/20 on the front and 275/40/20 on the back, is all good?
  15. At the Dragstrip
    Is Q16 leaded , if so will it screw up my cats and other stuff? I'm thinking MS 109 is not leaded is that correct??
  16. FLXC
    This club /group is pretty much done right? Like they dont meet or anything correct?
  17. Engine / Intake / Exhaust / Performance
    I had run both in the past, felt the 2pc chromoly was overall smoother, and I never liked the angles the aluminum 1pc produced on the pinion. Also so I had to cut the “ears” off where the stock driveshaft guibo bolted up. That said I now see DSS provides a diff spacer which looks to correct...
  18. Charger Discussion (2nd Gen - 2011 to 2014)
    On a 2012 SRT the "Active"exhaust valves they are there to stop the drone in 4 cylinder mode,and improve the sound, correct? Also how to you make sure they have the correct spring pressure on them? Thanks.
  19. 300 General Discussion (1st Gen - 2005 to 2010)
    Could I use this on my 06 Chrysler 300 srt8 It's dropped I'm having a hard time with struts and shocks they keep blowing out so I'm just going to put it back to stock height. but im not sure if these are the correct ones
  20. 300 General Discussion (1st Gen - 2005 to 2010)
    My Daytime Running Lights are currently disabled. My understanding is that when on they use the high beams at a reduced power level. Is this correct? I want to change my halogen bulbs to HID on the high beams, the low beams are already factory HID. Will reactivating the DRL's cause issues with...
1-20 of 20 Results