I have a 2013 Charger Police which has had a 6.4 engine swap done on it....including having the PCM flashed with a stock 2013 6.4 code. The 6.4 Chargers/300s of this vintage came factory with an exhaust pressure sensor in the driver's side mid-pipe which reads exhaust back pressure (I've read many people get this tuned out with aftermarket tuners).I've purchased the factory sensor/install kit because I'm trying to get the car to pass state inspection. Naturally, my check engine light is on because I don't have it connected (please don't advise to have it tuned out...)Does anybody have a picture of this sensor in their exhaust mid-pipe?? I have scoured the Internet and cannot find one. All I need at this point is to get a bung welded into my exhaust pipe where the sensor screws into, but I don't know approximately where.Thanks!
These are the SRT headers and mid pipes I got to run on my 05' 300C They came off a 2013 SRT Charger. In this picture you can see the 3 bungs on the drivers side pipe.(on the right side of the picture) The pressure sensor is the one behind the cat. Since I didn't need it on may built I just welded it shut.
Dam just noticed this is second gen... I’m in the wrong place sorry mine is 19
Sent from my iPhone using Scat Pack Forums
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
LX Forums Forum
5.2M posts
122.9K members
Since 2004
A forum community dedicated to all LX owners and enthusiasts including Dodge Charger, Challenger, Magnum, Hellcat, SRT8, and Chrysler 300. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!