![]() |
| Serving the LX Community for 6 years. 2004-2010 |
|
Not a member of LXForums?
|
|
|
|
|||||||
|
|
| General LX Discussion |
![]() |
|
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
|
Omg guys you have to see this giant ass blower no f=ing way!!!!!!!!!!!
Just watch till the end of the video!!!! TRAIN TWIN SQREW!!!!!!!. ANY ONE HAVE ANY OTHER INFO>>>
http://videos.streetfire.net/video/H...the_119334.htm
__________________
![]() Builder Bill Flywheel, Pro Torque 2800 stall,K&N intake,25%UNDERDRIVE PULLIE, FLOWMASTER custom exsaust,DIABLO 91 cai tune,ZEX 100shot nitrous ,MSD window switch, talor shorties, DYNATEC SUPERMAXX long tubes, and power cats..180 t-stat.Tinted tails done buy me. and lots lots more visual mods...race worrior cam NOT INSTALLED![]() 386 HP at wheels 466 tq at wheels on 100 shot need tunning worked out Last edited by 05silvhemimag; 10-23-2009 at 10:53 PM. |
|
#2
|
||||
|
||||
|
Blip the throttle...Raise the tires off the ground and blow both head gaskets....Now that's some boost!!
__________________
![]() PPP stage 3 heads, PPP stage 2 cam - 212/218 546/555 114 LSA, forged pushrods, 6.1 lifters, Powerbond 25% UD pulley, JBA headers, JBA high flow mids, Corsa exhaust, JET 180 thermostat, Diablosport Predator, CMR tune by Ditos Motors, ARIA "M" CAI, Taylor 8mm shorty wires, Eibach Sportline springs - Eibach Pro Dampers - Eibach front & rear sways, REM adjustable endlinks - REM front strut bar, SPC rear camber bushings, R1 Concepts drilled/slotted rotors, 22" x 9.5" - KMC DIME wheels, 265/35/22 - Dunlop SP Sportmaxx tires
|
|
#3
|
|||
|
|||
|
I can only dream............
__________________
![]() Val - 06 3.5, AEM CAI, Diablosport, JBA Shorties, Zoomers (Ladysmith BC) Roger - 08 5.7, AEM CAI, Diablosport, JBA Shorties, SRT8 Exhaust (Hemi Reg 1176) (Edmonton AB) |
|
#5
|
||||
|
||||
|
you know if they made the pullie bigger wouldnt that brind down the boost so then if it was say a 15 in pullie lol it would make consederable less boost.
__________________
![]() Builder Bill Flywheel, Pro Torque 2800 stall,K&N intake,25%UNDERDRIVE PULLIE, FLOWMASTER custom exsaust,DIABLO 91 cai tune,ZEX 100shot nitrous ,MSD window switch, talor shorties, DYNATEC SUPERMAXX long tubes, and power cats..180 t-stat.Tinted tails done buy me. and lots lots more visual mods...race worrior cam NOT INSTALLED![]() 386 HP at wheels 466 tq at wheels on 100 shot need tunning worked out |
|
#6
|
||||
|
||||
|
Total HP....2000.
Hp to run blower.....1800 Total HP = 200 I believe I heard this car exists but wrecked first time out due to the "weight transfer issues". Probably just "flipped to the right" off the line.
__________________
Net is where I be......Nathan is me * 2006 Charger SRT8 Inferno Red (Just a blur to most folks) with All Factory Options / Groups SRT8 Mats, Side moldings/rear ram's head shaved, Billet Technology in/out/under, DashHawk VID Madcharger engnie covers, KillerGlass Pipe, Hotchkis sways, Paws are Vredestein 275/40/20 Ultrac Sessanta C&L CAI, 180 Tstat, Magnaflow Catbacks, DynoSteve + Predator + CMR = "Custom Dyno/Street Tuned PCM" |
| Sponsored Links |
|
LXForums Message Board | Dodge Charger | Dodge Magnum | Chrysler 300 | Dodge Challenger | LXForums Message Board |
|
#7
|
|||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||
If you watched the video you would have seen that it never made a pass or even out of the driveway, he bliped the throttle and blew the head gaskets off, and it rased the front wheels of the ground an inch.... in the video he dose flip it over with a normal blower.
__________________
![]() Builder Bill Flywheel, Pro Torque 2800 stall,K&N intake,25%UNDERDRIVE PULLIE, FLOWMASTER custom exsaust,DIABLO 91 cai tune,ZEX 100shot nitrous ,MSD window switch, talor shorties, DYNATEC SUPERMAXX long tubes, and power cats..180 t-stat.Tinted tails done buy me. and lots lots more visual mods...race worrior cam NOT INSTALLED![]() 386 HP at wheels 466 tq at wheels on 100 shot need tunning worked out |
|||||||||||||||||||||||||||