HELP! Installing new Low Beam HOEN 9006xs xenonmatch Bulbs

**aspen300cp** · 02-19-2006, 12:40 AM

I have tried twisting, turning, pulling, biting (jk) ect........but i cant get the low beam bulb out of the 300c headlight housing on either side.

I installed the 9005 high beams no problem, but the low beam 9006xs bulbs wont come out. How do i get them out.

I got the Hoen 9006 xs xenonmatch lowbeams which run at 80w, so i got the recommended hoen upgraded connector also. The connector is just a plastic male end connector with +/- wires hanging out the back. How should I go about installing them. Im not a very good installer when it comes to the cars electronical system, wires ect.....

SHADO' WARRIOR LTD.

**HEMI_Arbeitstier** · 02-19-2006, 10:24 PM

I would also like to find this information out, I want to get HOEN Bulbs, and need all the information i can get

**PaCharger** · 02-19-2006, 10:30 PM

twist left.........they are tight...the replacements never to be quite as tight. When you remove note the three jags, one is short (i think the top one), it will make the guess of getting them in easier. Now ...word of warning...i'm going by my charger, in case its a cruel DCX joke...:grin:

**fnkychkn** · 02-19-2006, 10:36 PM

you guys have HID?

**aspen300cp** · 02-19-2006, 10:56 PM

HOEN are halogen bulbs which have the a color clostest to the factory HID's. I Don not have the factory HID's so I am replacing the High/low/ and fog beams w/ xenonmatch HOEN bulbs. I have only installed the high beams thus far, because the fogs are on back order and the low beams since the bulbs require a hicher watage than stock, i need to install a recommended upgraded connector to handle the 80w. And that requires cutting the old stock connector off and splicing the wires and connecting the new upgraded connector for the 80w Lows 9006xs bulbs.

I need help w/ installing the upgraded connector. Should i do it myself or take it somewhere, and if so where, what kind of shop

kidcali