Results 1 to 4 of 4
LinkBack URL
About LinkBacks-
06-17-2012, 10:41 PM #1
Supporting Vendor
- Join Date
- Dec 2008
- Location
- Little Elm, Tx
- Posts
- 1,222
width of LX rear end rotor to rotor?
I am thinking hard about putting a lx rear sub-frame in my 64 polara project and I need to know the width rotor to rotor. Anyone know? Anyone have one sitting on the floor they can measure?
2012 Mopar 12 Chrysler 300
Stock
1964 Dodge Polara
542 Big Block
MSD Atomic EFI
4L80 Automatic w 3000 Stall
AJE tubular k member and coil over suspension
-
06-17-2012, 10:43 PM #2
LX Guru
- Join Date
- Jan 2007
- Posts
- 5,851
Why do a IRS from a lx?
1968 Dart Supercharged Gen III Hemi
-
06-17-2012, 10:43 PM #3
You want it when???!!!!!!
- Join Date
- Sep 2005
- Location
- Plattsburgh,NY/Lorain Oh
- Posts
- 32,680
I just went through this for my 50'........it was 65" if I remember .......way to wide for my car by 11". I have a feeling its too wide for the Polara as well.
PARAMOUNT HTCNag1,Flexplate,Converter,3.73 8.8 and Driveshaft,PWR 462 ,PWR Apache Heads,Billet Tech Covers,CTP Twins ,HHP parts support.Grille by DodgeMagnumGrille.com 10.67@126.78 so far.
RIP NHDave
-
06-17-2012, 10:47 PM #4
Supporting Vendor
- Join Date
- Dec 2008
- Location
- Little Elm, Tx
- Posts
- 1,222
The stock on is 59.5. If it is 65 I might be able to pull it off with the right offset wheels and a good mini-tub job. May just say screw it and go with a moser and a 4 link setup. Probably WAY less expensive.
At any rate, thanks for the info
Reply With Quote
Posting Permissions
Share This Thread