7db kit installed

[BlairW]

Well I got my 7db kit installed finally, first off, sounds great, tips look awesome, no more ugly resonator poking out the bottom, but I cannot get the pass side lined up the same as the drivers side. The drivers side went on perfectly, centered just right. The pass side if i get it perfectly centered is way too far "in", almost behind the fascia. If i set it to stick out the same as the other side, it rubs against the side of the cut out in the fascia. for now i have them both set a little off center ( to the outside ) just so that they are even, still looks pretty good, just not as perfect as I would like. Any suggestions?

And I know, , Ill get some if needed, and when I figure out how.

[44REDHAWK]

do you like ?????
i am looking for new exhaust for my 05 r/t...
any drone at highway speeds ?????

[Blastin_Bob]

See this thread on how to adjust. Your won't be too difficult since the tubing diameter is smaller. GP300X4 Installed with long Vid

Bob

[BlairW]

do you like ?????
i am looking for new exhaust for my 05 r/t...
any drone at highway speeds ?????

Ya, i like, not quite as loud as I thought it would be, but a very nice sound. And NO DRONE at all on the highway.

[BlairW]

See this thread on how to adjust. Your won't be too difficult since the tubing diameter is smaller. GP300X4 Installed with long Vid

Bob

Thanks Bob, how many times can the band clamps be loosened and re tightened, they seem to stretch a bit, and I dont want to ruin them.

[BlairW]

O.K. just finished readjusting and I think I got it right this time! Looks awesome. Went for a little cruise and am lovin the new music. Thanks for a great product Bob

[Blastin_Bob]

Thanks Bob, how many times can the band clamps be loosened and re tightened, they seem to stretch a bit, and I dont want to ruin them.

Just don't over tighten them cause they will break. You should be ok to remove them multiple times, the torque spec is 23-25 ft lbs.