Anybody paint their keyfob?
I was looking at adding a splash on color. I dont want it to look like sh*t or chipping after a couple of months. I would leave the buttons and logo stock, but just paint the housing. Anybody tackle this or something similar? How difficult is it to disassemble?
Sent from my PG86100 using Tapatalk 2
LMI Hammer Intake * Corsa Xtreme Exhaust * 22" Vossen 78s * SRT Rocker Panels * Modern Muscle 85mm Throttle Body
Diablosport Trinity 93oct * Hotchkis Lowering Kit * Weathertech Mats * GTS Blackouts * Color Matched Rear Window Wing * Mopar Lower Lip * Mopar Pedals & Door Sills * Check me out on Cardmain: http://www.cardomain.com/galler/15699699
Unscrew the small screw and take out the pieces inside carefully (including battery).
Lightly sand with 1000 grit, wipe with rubbing alcohol.
Use a small bit of adhesion promoter, let dry then spray whatever color you want in short light strokes (2-3 coats, 30 min drying time in between).
Let cure 24 hours.
Spray clear coat (2-3 coats with the same drying time and curing time).
Reassemble and your done!
That's how I did mine at least.
Hope this helps you.
Thanks, would you happen to have any pics of the outcome?