For those who have put dual exhaust on a V6

[black MAGic]

Any recommendations or suggestions on cutting out the driver's side lower bumper to accomodate the extra exhaust? All input is appreciated.

[Invader]

one sec, lemme dig it up. There's a kit w/ templates and facia pieces to put in to finish it off... hold on

Link to what they look like (still lookin for P/N)
**Mopar Borla Installed, and appearance mod**



Big props to MPSC!!

[MooNDoGGie]

Just make a template of the right side with cardboard and tape. Then reverse it and tape it on the left side. Use a dremel tool to cut the shape with the template as a guide. It will take you 20 minutes tops.

[DaILLestWun]

Most exhaust shops will do this for you.

[boggart]

My exhaust guy did what MoonDoggie lays out for making the template, but actually just used a box knife to open.

[ZMagnum]

My exhuast guy just took some measurements from the right side and then cut the left side. Then I painted the cut edge with touch-up paint. You can't even tell unless you look under the car.

[mfkbmagnum]

I did it just like Moondoggie. Very easy to do. Even a caveman can do it.

[Invader]

Even a caveman can do it.

GDI now I'm going to have to go through therapy!

[1sckmgnm]

Not to hijack thread but to all of you what exhaust did you go with.

[Invader]

Mopar/Borla

[mfkbmagnum]

Mopar/Borla also.

[ZMagnum]

Zoomers.

[Magma]

I did it just like Moondoggie. Very easy to do. Even a caveman can do it.

Same way mine was done... easy as pie!

Not to hijack thread but to all of you what exhaust did you go with.

Magnaflow

[Kuldip]

the muffler shop did mine, didn't even charge me the labour, just to install the borla/mopar exhaust setup, you can't tell wether we cut out the bumper or not. Thinking about removing the res.on the borla thsi weekend and trying it out.

[MooNDoGGie]

Duel Zoomers here.