I have had a few requests for info on how I made my custom engine cover insert, so I figured I would help everyone out with a write up on it. I have worked with plastics and modeling for over 25 years now, so it is a little hard for me to judge the difficulty level of a project like this. If you... 62 Comments
If your HCU (hydraulic control unit) looks like this -
- then you have the early "6 on top" style HCU and you will need to make some changes to the SLP kit to get it to work with your setup. Essentially you need to make a new "Master Cylinder to Solenoid" line and couple it to the... 3 Comments
All right guys, finally I could show you what I have done with my car!
I always wanted a cool loud and nice sound horn because I am sure our cars with their brutal appearance deserve it. But, on the other hand I definitely didn't want it to be as loud as a train horn. :-)
So I started... 4 Comments
Well, here's another "what you need to know" kinda deals. It's not intended to be a step-by-step, just more of a "Here's the important stuff" thread. It'll make a lot more sense if you've got the things in front of you than it will if you're just reading it ahead of time.
I'm not going to show... 35 Comments
Abstract
This knowledgebase post describes a potential hazardous and damaging condition that may occur due to corrupt PCM/ECU software. This condition may occur when restoring the original base tune from the Predator.
Predator Write Fail Condition
While attempting to restore the... 13 Comments
After installing a trailer hitch there is no need to spend the $100+ for the Mopar or similar harnesses.
Using a basic 4 wire tail light converter you can hook up your harness in a matter of minutes. I used a Hopkins #46155 Basic Taillight converter, I got at the parts store for $26. Any 5... 3 Comments
I was waiting to get more footage of the car with the halos at night, but each night in the past week or so has been busy or raining. Eventually I will repost this with some more footage and clean up some of the edits. When that happens, I will simply modify this post and video to v.2.0 and none... 13 Comments