I looked all over for a good matching paint, but struck out left and right. I don't know if different years and models have different A-pillars, but the '06 SRT8 is a tannish color with tiny black specks in it. This is what I wound up doing. To prep the black gauge pod, all I did was scrub it...
3 Comments

My Magnum had about 6k when the sunroof started to rattle. It is covered under the warranty but did not want to get the car back with a dirty headliner, so I fixed it myself. I searched these forums with no detailed info before I started so I decided to help others with the same problem fix...

Removal Step 1 Open the door and locate the small piece of trim that runs along the side of the dash. Simply grab onto the top or bottom and pull the piece toward you. It will pop off.

This is for most of us that didn't get to add this when we bought our cars new. Here is the complete assembly i got through Mopar Super Center: I only used the part that actually holds the filter: Here is the part #: Tools used for the install: 1/4" & 3/8" ratchets w/short...
26 Comments

Here is a step by step instructions of how to remove your seats from your LX. This is very easy thing to do to knock off another tenth or two off your 1/4 mile time. First time I did it, took me about an hour. Now I can do it in about 15-20 min. Tools needed: ratchet extender 18mm socket ...
25 Comments

This mod is intended to be an enhancement for the ShiftHammer. It is intended to be used for drivers whose hand positions during driving are not interfered by shift paddles causing safety concerns. I will not be responsible for the acts and safety of drivers who choose to copy this mod. This...
34 Comments

HI guys, Here are the instructions & Pics for removing the wheel inserts if you want to paint them. Picture 1: To remove the lower inserts use a jewelers screw driver or credit card and insert as shown. You do not have to remove the air bag assembly to remove them (in case you only want to do the...
5 Comments

How-To: changing out door handles... I did this a little under a year ago so lets hope I remember all the steps: first I don't recall all the tool sizes needed so if anyone is doing this in the near future please PM me for corrections. As I recall: tools needed: Phillips Screw driver, ...