To start off My headlights look like crap! I don't know how I ever had my headlights get like this. My headlights were so scratch and had no clarity at all and I needed to do something about it and this is what I did......:thumbs_u: First: Go to your auto supply store and buy the Meguiar's...
2 Comments

Heres my little write up for the Mopar fog lights PN# 82209665. EDIT: this write up is for 05-07 LX models... 2008 and newer models have a different wiring harness and do not require half the steps in this process. 1st Step: Wash and Detail charger :wax:
1 Comments

Heres my little write up for the SRT-8 grill PN# 82209978 I purchased it at the dealer for $39.99 and it came next day... I tried to start doing this install by following the directions but ended up breaking 3 out of the 8 clips holding on the front fascia so i made an easier way for you...

My Magnum had about 6k when the sunroof started to rattle. It is covered under the warranty but did not want to get the car back with a dirty headliner, so I fixed it myself. I searched these forums with no detailed info before I started so I decided to help others with the same problem fix...
1 Comments

I bought my Mag because I like wagons for their utility. SO any good wagon should have a roof rack. Since most SRT's don't I put one on myself. Before you decide to mount the factory rails on your car make sure you want them there - FOREVER. You will make you roof ugly under the mounting...

The following procedure outlines the requirements to install the Dodge Charger 05 - 07 SRT8 Rear Diffuser on the Dodge Magnum 05 - 07 (Non SRT8) Rear Bumper. It turns out the Charger SRT8 Rear Diffuser is essentially a bolt on modification that will improve the look of your Magnum. ...
3 Comments

I couldn't resist documenting my hood-strut install. It's so easy! The hood strut kit runs about $60 from your favorite Mopar dealer. The kit should contain the following Mopar parts: 1- 5065278AD Cylinder 1- 5065279AD Cylinder 2- 6507889AA Ball Stud The only tool required is a 13MM...
8 Comments

This is a Step by Step how to replace your Magnum Tail Lights. Tools needed: Long Reach 11MM Wrench (preferable) or 11MM Socket 1/4" Drive and 1/4" Drive Ratchet Slot or Flat Blade Screw Driver Plastic Trim Tool Step One Locate tail light access cover, it is a grill looking rectangle...
1 Comments