As part of my entire front suspension upgrade on my 2005 3.5L V6 RWD 300, the Inner and Outer Tie Rods are getting replaced. I'm replacing the stock/OEM ones with MOOG parts. Please note, that I am removing all parts on the front end, but this write up is exclusive to the Tie Rods so some pictures...
24 Comments

As I expected, this install was not a cut and dry swap from the stock struts to the BC struts. The following is my experience with the install procedure. To start, here's a picture of the front strut parts. The front spring has been removed from the BC strut, as it obviously won't be needed....
22 Comments

Well, it will happen someday. Your RWD LX'es lower ball joint boot will tear or get torn, let water in and eventually get noisy then loose. The one on the left: Currently, Chrysler will not service the ball joint seperately, although the special tools and service manual directions exist to do...
16 Comments

I completed my install and put in some time on them on the road and at the track...here are my experiences and thoughts with some ride height adjustment info. (this thread is work in progress, I'll update as time allows) In this thread I will concentrate on the front and rear installation,...
65 Comments

Here they are! With that, lets get to the install.
54 Comments

So you want to polish your brake calipers. This easiest way to do this is if you have an extra set of calipers to work on without taking your car apart and not being able to drive it. In my case I was able to get a set of R/T calipers to work on so that I could replace my V6 brakes. This will...
20 Comments

First your gonna want to raise the car up and secure them on suitable jack stand..... OR you can just put your car on the lift. I know everyone has a lift. :p Tools needed Impact Wrench/Breaker Bar 21mm socket Torque Wrench Small Punch Hammer Large Pliers
22 Comments

I recently did this swap, and learned a lot in the process. You all know how I like to consolidate things and get all the right info in one place, and that's what I want to do here. This is not intended to be a step-by-step write-up on how to do it; instead it is a place where all the common...
43 Comments