question on demolding and debadging

[pgcharger]

i know so cars with the small molding like the charger has it has pins along with the dub sided tape is that the same with the chargers? or can i just pull it off and clean up where it used to be? thanks in advance

[blackmagnum06]

no pins or clips on the molding. it is glued with adhesive. just get some heat lamps fishing line and do it slowly.

[bigdog425]

ya it is such a good look. i did it on my 300 made a world of diffrence.

[Demon]

Planning on doing this myself... supposed to snow tomorrow so doubt I will be out there with my heat gun any time soon...

[BUTWEET]

Definitely not something to do in cold weather.

[pigpen]

Cold weather will suck big time.

It is best to use a hair dryer to heat them up a little bit. Then use goo be gone to get rid of the crude.

[Demon]

I've got an OLD heat gun, works really well for moldings... I bet it could even do the job while it was snowing... I just wouldn't be LOL

[Bruce Bruce]

If you put in chrysler demolding on you tube, it shows you a simple visual on how to take it off

[sublime195]

I just de-moulded my sublime and it was only about 25 degrees. Was easy to do. Just be paitent and a hairdrier will work good. The trick is to get tthe moulding started. With mine the tape came off with the moulding.