Halos

[ColeMonkey]

I was just wondering if anyone has had any problems with them? Like staying on? I'm not sure how they are attached, glue or what?

The reason I ask is cuz on my Cougar I had, I had Halos and they kept breaking off! The guys on the Cougar forum said to use the wire from the twisty ties, but those kept breaking on others Cougars so they said to use epoxy glue. So I did! And it worked very good till... the glue turned yellow and then cracked, letting the halos loose and bouncing around in my headlight!

So any info would be appreciated for when I get my Magnum and install these. Thanx guys & gals!

[lowriderman3]

They are glued on. Never had that type of problem with mine on this car or my last.

[ColeMonkey]

What kind of glue did you use???

[lowriderman3]

What kind of glue did you use???
Someone else might be able to chime in. I had AAC mod mine so they already came installed.

[ColeMonkey]

bump

[MR. J]

Epoxy is what AAC recommends to use for their DIY kits so I would assume epoxy is what they use in their pre-built headlights.

[HemiLover]

Epoxy....that 2 part mix stuff thats clear. Just a drop in a couple spots on the rear of the halo ring and at the rubber wire boots that go thru the bezel.

[ColeMonkey]

Hmmm, cuz I had a bad experience with that...

[rsmeanie]

I had AAC install mine and I think they used epoxy. If you look cafefully, you can see a couple of small blobs on each ring. No problems whatsoever.

http://img.photobucket.com/albums/v516/rsmeanie/SRT-8/Tommy%20Z%20Grille/IMG_1758.jpg

[ColeMonkey]

I'll probly have them just do mine then.

[dgreekman]

No problems here....even on the newly installed tail halos
http://i69.photobucket.com/albums/i41/dgreekman/tail_light_tighter.jpg