Camshaft Position Sensor Replacement

[swagon]

Here is a quick post on replacing the camshaft sensor.

1. Disconnect the negative battery cable.

http://i143.photobucket.com/albums/r150/brascal/random084.jpg

2. Locate the camshaft position sensor, it is on the passenger side in the front on the block.

http://i143.photobucket.com/albums/r150/brascal/random075.jpg

3. Remove 10mm bolt and remove camshaft sensor.

http://i143.photobucket.com/albums/r150/brascal/random076.jpg

4. Unplug sensor, apply dielectric grease to new sensor and plug in, apply a small amount of grease to o-ring, replace into block and tighten bolt. Can't remember torque spec but will update it when I find it back.
5. Reconnect battery cable.

http://i143.photobucket.com/albums/r150/brascal/random085.jpg

[MOL SRT-8]

why did you unhook the battery? that part alone takes more time them the rest of the job.

[swagon]

why did you unhook the battery? that part alone takes more time them the rest of the job.

I was doing my crankshaft position sensor at the same time and to cover my a$$.

[MOL SRT-8]

I was doing my crankshaft position sensor at the same time and to cover my a$$.

cool.