2008 300C Adjustable Pedals Help

[BobFam]

I just got back from a long trip and found that my adjustable pedals don't work anymore. I tried using the seat mounted switch with the engine (http://www.300cforums.com/forums/#) off and on, and with the key off. As I remember the pedals could be adjusted in all modes. I don't hear any motor at all., I looked in the owners manual and did not find a fuse listed for it. Is it controlled by a fuse, and if so which one is it? I don't want to waste time going to the dealer if it's only a fuse. If replacing the fuse causes it to blow I'll go to the dealer to get it fixed. The adjustable pedals should be the same in all the car lines, I think. Thanks, regards, Bob.

[InfernoR/TGirl]

Don't know, never use them.... I always figured that was why seats were adjustable.

[BobFam]

Hi. Thanks. The only time I use them is to readjust them after the "shrimps" at the carwash move them. Best regards, Bob.

[GasGunR]

Make sure it's not in gear or neutral. Must be in park IIRC

[fnkychkn]

adjustable pedals should work at all times except when in reverse or when cruise control is engaged.

assuming you have memory system. adjustable pedals are powered by a HSD (high side driver) in the MSM (memory seat module). the MSM gets power from CB1 (circuit breaker 1) in PDC (power distribution center/ rear fuse box). if power seats/power column tilt-telescope/heated seats still work, the power supply should be OK. check connections at the module under the driver's seat.

[BobFam]

Hi. Thanks. According to the Owner's Manual they should work in all modes except Cruise and Reverse. As I remember that's how they did work when they were operating OK. Regards, Bob.

[BobFam]

Hi Fnkychkn. I have the memory system. The power seats, power column tilt-telescope and heated seats all work. Now that I think about it I believe the pedals did work before the guy vacuumed under the seat at the car wash. I'll check that in the AM. Thanks. I do not have the 2008 SM so I could not check it out myself. I have a 2005 and 2006 SM I'll look at it to see if it's the same. Best regards, Bob.

I checked and there are no loose connectons under the seat on the module. I'll be off to the dealer on Monday.

[BobFam]

Hi Fnkychkn. You were 100% right, as always! There was a broken connection in the wiring harness under the seat. He fixed it with a P/N 4778570 Sleeve HE 8059040, all under warranty. They even washed it for me and removed some small sticky labels that had been on the rims since I bought it. Thanks and best regards, Bob.

[InfernoR/TGirl]

Glad you got it figured out :banana: Sorry for being a smarty pants before, sometimes I get kinda sassy! No harm intended. :)

[BobFam]

Hi. No problem. When you are tall and big like I am I need all the room I can get! I had a little PT Cruiser as a rental car while I was getting it fixed. It sure was a pleasure to get my car back. I can see how Chrysler has problems after driving that car! It was a real POS. Best regards, Bob.

[fnkychkn]

glad you got it fixed, Bob.

[BobFam]

So am I. Thanks for your GREAT help. Best regards, Bob.