PDA

View Full Version : Can I install the lower gears from the V6 models into my RT / 300C? *

DMAG
03-26-2005, 05:57 PM
**New Info posted further down in this thread**

Can I install the lower gears from the V6 models into my RT / 300C?

In a word... No.

Unfortunately, the rear axle carriers in the V6 model LX's are different sized then the V8 models. Though, the AWD models are noted to come with the V6 gears.

No aftermarket suppliers have offered any retrofit gears for the RT/300C, but with enough interest, who knows?
graymagnum
06-03-2005, 10:43 PM
use rear end gear from awd rt-mid 3s, i may do the same...but say goodby to your road millage-a hi 3s 2spd would do it all
Rev.Hammer
06-04-2005, 08:07 AM
This MAY work or it MAY be an expensive mistake. The gears for the AWD are not as robust as the FWD. The reason being it doesnt have to live with as much torque.
Also, instead of swapping gears , swap center sections, this way the backlash, depth, and center are already set and you wont have to lay up under the car doing it..
done
06-04-2005, 08:20 AM
This MAY work or it MAY be an expensive mistake. The gears for the AWD are not as robust as the FWD. The reason being it doesnt have to live with as much torque.
Also, instead of swapping gears , swap center sections, this way the backlash, depth, and center are already set and you wont have to lay up under the car doing it..

Actually, you are making an assumption about the torque handling. That is really not known for sure.

But swapping the whole "pumpkin" would seem to be the best way to approach, but again, it is not known if this will work until someone finds a "badly mis-treated" AWD and trys it.
Fred
06-04-2005, 10:37 AM
Well if someone local wanted to swap an AWD rear for RWD rear I'm up for it... I gots the AWD and would like to pick up the highway mileage a little.
needasrt4
06-04-2005, 02:00 PM
were are you at
RobAGD
08-07-2005, 03:12 PM
Fred - You may have a problem doing that as changing only the rear gears would cause you to have your fronts and back turning at differnt speeds. Bad bad things typically happen when you do that.
Hemi31
12-09-2005, 08:15 PM
SRT-8 gears should be available.They are 3.08 also.
RobAGD
08-12-2009, 09:42 PM
OK Updated info on this:

The Diablo Predator now supports serveral aftermarket gear sets for the LX line, be they from the V6, SRT8, Richmond Gear, or the newer LSD Rear Ends from Getrag ( the factory parts for some of the Challengers )

So now the offical answer is YES

-Robert